US/JP Mod switch for PC Engine/Core Grafx/Turbo Grafx etc

$16.00

An 8 pole double throw switch, wired up with all the right connections for the minimal fuss installing it in your system. Comes with switch, full instructions for installation, heat shrink to protect the connections and strong epoxy putty to secure the switch in your console. This switch will work on all PCE systems bar the LT and GT (as it is too big to fit in these units). As it is fully mechanical it will cause no power drain and the thin gauge wire included (fully colour coded for easy installation.) The push button switch measures just 3mm by 3mm so while you will need to make a hole in your system, it need only be a very discreet one. This switch is especially recommended for Duo systems as the switch goes neatly in the back.
<p>
You will also need: Low wattage soldering iron (18-25W recommended, 30W has been found to not damage PC engines however, but I would err on the side of caution)
<p>